STAS riva wooden rail 200cm

Our wooden rails are made out of Ayous wood and are FSC and PEFC certified. Ayous wood differs from other, cheaper wood since it does not deform nor splinter, and is perfectly suitable to repaint because of its smooth texture. Perfect wood for your picture hanging system! Can be mounted with screws, nails and glue*. Experience the pleasant warmth of wood in your interior!
* The bearing capacity of a glued rails is highly dependent on the surface, so care must be taken here. More information on how to best glue our wooden rails can be found below.

n.b Natural wood is a natural, living material, every tree features a unique fingerprint of lines, knots, and colour swirls. Bare woods display these raw, organic variations more than other finished woods. We do our best to match grain and colour between lengths as far as possible but it is not always possible. The wood can be painted or stained to get a more consistent finish. Please bare that in mind before purchasing.

The following hooks and cords can be used in combination with this system:
STAS smartspring on STAS perlon cord with loop (can be loaded up to max. 4 kg)
STAS zipper on STAS perlon cord with loop (can be loaded up to max. 15 kg)
STAS zipper on STAS steel cable with loop (can be loaded up to max. 20 kg)

5-Step Plan for glueing the STAS riva

Step 1: Assess the surface
When glueing the STAS wooden rails it’s very important that the surface is well fixed and firm. This goes especially for wall paper. The wall paper must have been applied tightly and evenly to allow the STAS wooden rails to adhere as well as possible.
Step 2: Pick the right glue.
We recommend a glue that is especially designed to offer a very good adhesion on wooden surfaces. We advise you to go see your local DIY store for further recommendations.
Step 3: Pretreatment
Make sure that the surface and the STAS wooden rails are clean, dry, dust- and grease free before you start glueing.
Step 4: Glueing
The glue can best be applied in strokes (so don’t cover the whole rails in glue). Once the glue is applied you can place the STAS wooden rails on its surface (make sure it’s level!). The STAS wooden rails can at this point still be adjusted. When the rails are in the right place you can exert pressure so that the STAS wooden rails is well attached to the surface. Then allow the glue to dry for 24 hours.
Step 5: Hang your wall decoration
Hang your favorite wall decoration using the STAS hooks and cords and admire the result!